6 methods for the use and daily maintenance of ventilation lock forming machine equipment
- The four handles on the side should be used for manual handling or ventilating equipment lock forming machine machine lifting. Do not force the table panel, or even use the lifting panel to lift the machine.
- Calcium-based grease is often added to the transmission tooth surface to reduce the tooth surface wear and tear.
- Keep the surface of the rolling wheel clean, clean up the adhesive in time, and the ventilation equipment lock forming machine machine Co-plate flange machine Duct plasma cutting machine When the duct production line is out of service for a long time, apply anti-rust grease on the surface of the rolling wheel.
- Frequently check the working conditions of the system. Pay special attention to the needle roller bearings. If they are damaged, they should be replaced and repaired immediately, and they must not be used reluctantly.
- If it is found that the speed of the rolling wheel is slow or the operation is weak, it may be caused by the slack of the V-belt. You can move the motor position and re-tension the V-belt to recover.
Back to normal.
- Every six months is a maintenance cycle. The upper and lower frame wall panels and needle bearings should be disassembled, and ZL45-2 kang-based grease should be reapplied.
Workers should follow the operating procedures when using the ventilation equipment bite machine duct production line
1 When operating the ventilating equipment lock forming machine machine, do not push the workpiece directly with your hands.
2 When using the air pipe production line of the ventilation equipment, it is strictly forbidden to reach into the gap of the mechanical pressure plate. Tools and other items are not allowed to be placed on the upper knife holder, and feet cannot be placed on the shoe plate when adjusting the plate. When using a fixed vibrating shear, both hands should support the steel plate, and the hand should not be less than 5cm away from the knife edge. The force should be even and appropriate.
3 When operating the bite, the finger is not less than 5cm away from the roller to protect the light. The handle shall not be placed on the track of the air pipe production line of the ventilator bite machine, and the sheet should be stabilized.
4 Electric tools should be arranged indoors or in custom-built work sheds to prevent rain and snow. When using ventilation equipment to bite the machine, check whether the parts are flexible and reliable. It is strictly forbidden to touch the blade and the bottom surface of the presser foot by hand. If two people cooperate with cutting materials, they must coordinate with each other. Only when the agreement is reached, the switch can be pressed.
5 The air duct production line should cooperate with each other and keep a distance from the air duct production line during processing, so as not to be injured by the overturned steel plate and counterweight.
6 When using profile cutting, first check whether the protective leather is reliable and whether the silver sheet is running normally. When cutting, the profile should be accurate and fixed before pressing the saw blade down for cutting, and the force should be uniform and moderate. When using the drill press, it is not allowed to cut gloves.
7 When using toxic solvents such as carbon tetrachloride to lubricate the aluminum plate, it should be filled in the ears. If it is indoors, the doors and windows should be opened to adopt mechanical ventilation.
8 Strictly design water and electricity in accordance with the project construction organization to avoid over-planning and waste. On-site pipeline layout should be reasonable, and no random connection or use should be made. Special personnel should be assigned to manage the on-site water and electricity use.
9 The work site must be equipped with a fire extinguisher or other fire fighting equipment.
